SHARP

Language

SELECTING THE ORIENTATION AND SIZE OF THE ORIGINAL

When the original size is a non-standard size or is not detected correctly, manually specify the original size.
Set the orientation of the image to ensure that the orientation of the placed original is correctly recognized.

Set the orientation and size of the original before scanning the original.

SPECIFYING THE ORIENTATION OF THE ORIGINAL

By specifying the starting side (top or left side) of the placed original, the orientation of the original will be correctly recognized.
Finishing position settings and N-Up layout settings are specified using the recognized orientation.
In Easy mode

In Normal mode

SPECIFY THE ORIENTATION AND SIZE OF THE ORIGINAL

Tap the [Original] key to set the orientation of the original.

COPY MODE

Tap the [Auto] key.

Tap the appropriate original size key.

After the settings are completed, tap [OK] key.

SPECIFYING THE ORIENTATION AND SIZE OF A NON-STANDARD SIZE ORIGINALS

Tap the [Original] key to set the orientation of the original.

COPY MODE

Tap the [Auto] key.

Tap the [Direct Entry] key.

Specify the original size.

After the settings are completed, tap [OK] key.
  • Tap the areas displaying width and height sizes respectively, and enter the sizes using the numeric keys.
  • It is convenient to use to finely adjust the entered size.

Tap the [OK] key.

Make sure that the original size you have set is displayed in the upper left corner of the screen.
Language

Version 04a / bp70c65_usr_04a_en

↑Top of page