SHARP

Language

INNER FINISHER

This device outputs sorted paper while staggering each set of paper. As needed, it staples each set. You can also perform stapling manually.
To punch holes in printed paper, install an optional hole punch module.

PART NAMES

The following describes the parts that appear when the finisher is open.

Output tray

Stapled and offset output is delivered to this tray.
The tray is slidable. To print on large paper such as 11" x 17" (A3) size, extend the tray.

Manual staple key

Press to execute manual stapling.

Punch waste box (when a punch module is installed)

This stores punch waste discharged from punching.

Insertion slot

Place the paper that you want to staple in this slot. Maximum thickness 11/64" (4 mm).

Front cover

Open this cover to remove a paper misfeed, replace staples, remove a staple jam, or remove the punch waste box.

Staple case

This holds the staple cartridge.
Pull the case out to replace the staple cartridge or remove a staple jam.

Staple case release lever

Use this lever to remove the staple case.

Lever

Use this lever to move the finisher in order to remove a paper misfeed, or remove a staple jam.

  • The inner finisher cannot be installed at the same time as the folding unit, finisher, finisher (large stacker), saddle stitch finisher or saddle stitch finisher (large stacker).
  • Exercise caution when you turn on the power and when printing take place, as the output tray may move up and down.

HOW TO STAPLE MANUALLY

You can perform stapling manually.
Make sure the manual staple key is lit green.

Place the paper that you want to staple in the insertion slot.

When you place the paper, the manual staple key blinks green.
After two seconds elapse, stapling automatically starts.
  • To staple earlier than the auto staple start time, press the manual staple key.
  • Manual stapling cannot be executed during execution of a staple job.
  • Manual stapling cannot be executed during auto power shutoff mode.

Relation between paper orientation and stapling result

Paper Paper orientation when inserted After stapling

SUPPLIES

The finisher requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
MX-SCX1

INNER FINISHER MAINTENANCE

When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the operation procedure to replace the staple cartridge.

Replacement the staple cartridge

Open the finisher front cover.

Lower the staple case release lever and remove the staple case.

Pull the staple case out to the right.

Remove the empty staple cartridge from the staple case.

Insert a new staple cartridge into the staple case as shown.

Push the staple cartridge in until it clicks into place.

Push the staple case.

Push the staple case in until it clicks into place.

Close the finisher front cover.

Make a proof copy in staple function to verify that stapling takes place correctly.
Staple ON (excluding saddle stitch)

CONTENTS MENU

Language

Version 06a / bp70c65_usr_06a_us

↑Top of page