FINISHER

Output tray (upper tray)

The tray is slidable. To print on large paper such as 11" x 17" (A3) paper, extend the tray.

Output tray (lower tray)

Stapled and offset output is delivered to this tray.
The tray is slidable. To print on large paper such as 11" x 17" (A3) paper, extend the tray.

Top cover

Open this cover to remove a paper misfeed.

Front cover

Open this cover to replace the staple cartridge remove a staple jam or remove a paper misfeed.

• To install a finisher, a paper pass unit or folding unit and stand/550/2x550/3x550/550&2100 sheet paper drawer are required.
• A finisher cannot be installed simultaneously with an inner finisher, finisher (large stacker), saddle stitch finisher or saddle stitch finisher (large stacker).
• Do not place heavy objects on the finisher or press down on the finisher.
• Exercise caution when you turn on the power and when printing take place, as the tray may move up and down.

The finisher (large stacker) requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
MX-SCX1

When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the operation procedure to replace the staple cartridge.

Replacement the staple cartridge

Open the front cover.

Pull out the staple unit.

Remove the staple case.

Remove the empty staple cartridge from the staple case.

Insert a new staple cartridge into the staple case as shown.

Push the staple cartridge in until it clicks into place.

Push the staple case firmly back in.

Push the staple case in until it clicks into place.

Replace the staple unit.

Close the front cover.

Make a proof copy in staple function to verify that stapling takes place correctly.
Staple ON (excluding saddle stitch)