This device outputs sorted paper while staggering each
set of paper. As needed, it staples each set. You can also perform
stapling manually. To punch holes in printed paper, install an optional
hole punch module.
The tray is slidable.
To print on large paper such as A3 paper, extend the tray.
Stapled and offset
output is delivered to this tray.
The tray is slidable. To print on large paper such
as A3 paper, extend the tray.
Press to execute
manual stapling.
Open this cover to
remove a paper misfeed.
Place the paper that
you want to staple in this slot.
Maximum thickness 9 mm.
Open this cover to
replace the staple cartridge, remove a staple jam or remove a paper
misfeed.
You can perform stapling manually.
Make sure the manual staple key is lit green.
Place the paper that you want to staple in the insertion slot.
When you place the paper, the manual staple key blinks green.Paper | Paper orientation when inserted | After stapling |
---|---|---|
![]() |
![]() |
![]() |
![]() |
![]() |
The finisher requires the following staple
cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three
cartridges)
MX-SC11
When the staple cartridge runs out of staples,
a message will appear in the operation panel. Follow the operation procedure
to replace the staple cartridge.
Open the front cover.
Remove the staple case.
Remove the empty staple cartridge.
Insert a new staple cartridge into the staple case.
Push the staple cartridge in until it clicks into place.Push the staple case firmly back in.
Push the staple case in until it clicks into place.Close the front cover.
Version 02a / bp70m90_usr_02a_en