This device outputs sorted paper while staggering each
set of paper. As needed, it staples each set.
The following describes
the parts that appear when the finisher is open.
Stapled and offset
output is delivered to this tray.
The tray is slidable. To print on large paper, extend
the tray.
Open this cover to
remove a paper misfeed, replace staples, or remove a staple jam.
Use this lever to
move the finisher in order to remove a paper misfeed, or remove
a staple jam.
Use this lever to
remove the staple case.
This holds the staple
cartridge.
Pull the case out to replace the staple cartridge
or remove a staple jam.
The finisher requires the following staple
cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three
cartridges)
MX-SCX1
When the staple cartridge runs out of staples,
a message will appear in the operation panel. Follow the operation procedure
to replace the staple cartridge.
Open the finisher front cover.
Push lever and move the finisher.
Lower the staple case release lever and remove the staple case.
Pull the staple case out to the right.
Remove the empty staple cartridge from the staple case.
Insert a new staple cartridge into the staple case as shown.
Push the staple cartridge in until it clicks into place.
Push the staple case.
Push the staple case in until it clicks into place.
Return the finisher to the first position.
Close the finisher front cover.
Version 01b / bpc545wd_usr_01b_us
